SPIDER MK-250 DISASSEMBLING INSTRUCTIONS

How to disassemble a SPIDER MK-250 crossbow: Tools: Screw Driver, Pin-Shaped Nail, Rubber Mallet   1. Position the SPIDER MK-250 crossbow on its right side, then you will need to locate a small bolt that is inserted inside the scope mount frame(the bolt should not be the one that is connected to the scope knob adjuster). Then using your hammer and a pin-shape nail, you will need to place your nail on the (1) small bolt and gently hammer the bolt so that it can come out loose thru the other end (basically your using the nail to push the bolt out the other end). 2. The scope mount frame should easily slide off, after the bolt was pushed out. Then you will find (2) screws located inside the scope adjusters frame. 3. Using your screw driver gently remove the (2) screws. Make sure to have a small container where you can store these small screws and bolts. 4. The scope adjuster frame should then be able to come off easily. 5. Now you should have a crossbow with no scope adjuster frame and prepare your screw driver for the next step. 6. Using your screw driver gently remove the (1) top screw and place it in your small container with your other bolts and screws. Now all you should have in front of you is crossbow with no scope mount or scope adjuster. 7. Position your SPIDER MK-250 crossbow on its right-side and locate the (2) screws. Then gently remove the (2) screws from the right-side. 8. After you are done with removing the (2) screws from the right-side, position your SPIDER MK-250 crossbow on its left-side and remove the other (2) screws. Remember to place the screws in your small container. 9. Now you are going to position your SPIDER MK-250 crossbow upside down so that you can view the bottom part, there you will locate (1) screw that is inside the camouflage frame and you will need to remove it. 10. Now your metal frame is ready to be separated from its camouflage frame, by using a rubber mallet gently hit the metal frame. 11. Without any difficulty the metal frame should be able to separate from its camouflage frame. 12. You should have two separate parts your camouflage frame and your metal frame. 13. Position your metal frame on its right-side and remove the (2) screws. 14. Position your metal frame on its left-side and  remove the (2)screws. Don't forget to put the screws in a small container. 15. After you are done removing the two screws from each side, you should be able to slide out the trigger frame. 16. You are now finished and have disabled your SPIDER MK-250 crossbow.